American Marconi Wireless News - US regulator urges safety checks on some Boeing 737 rudders

It came after a February 6 incident involving a Boeing 737 MAX 8 operated by United Airlines, whose rudder pedals were "stuck" in the neutral position while on the tarmac after landing at Newark airport in New Jersey.

None of the 155 passengers and six crew members were hurt, the NTSB said, with the captain using the nose landing gear controls to steer the plane.

Boeing has come under increasing pressure following a number of safety incidents involving its aircraft. It did not immediately respond to an AFP request for comment.

The cause of the February incident was found to be the rollout guidance actuator, one of the rudder control components, with tests revealing it was susceptible to moisture which could "freeze and limit rudder system movement," the NTSB said.

The faulty actuator was manufactured by US company Collins Aerospace, it added.

"Collins notified Boeing that more than 353 actuators that Collins had delivered to Boeing since February 2017 were affected by this condition," the NTSB said.

The part is installed in the tail of some Boeing 737 NG and 737 MAX airplanes.

The Federal Aviation Authority said it would convene a corrective action review board on Friday based on the NTSB's recommendations to determine next steps.

Boeing has been under close regulator scrutiny since an in-flight incident involving an Alaska Airlines 737 MAX 9 aircraft in early January.

That event saw a door plug blow out mid-flight, leaving a hole in the side of the aircraft.

Boeing's quality control and production processes had already been called into question after the crashes of two 737 MAX aircraft in 2018 and 2019, killing 346 people.

In March, the US aviation giant reshuffled its leadership, with new boss Kelly Ortberg taking over on August 8.

Ortberg had headed Rockwell Collins, the company which later became Collins Aerospace, from 2013 to 2018.

L.Durand--AMWN